Hollow Fast Tail Stock Mount Set Up
For additional reference: H750 Tail Stock Mount schematic drawing with part numbers
1. Assemble mounting brackets to "A" bracket: Bolt on "B" Bracket as show for Midi Lathes and add "C" Bracket for large lathes over 8" center height. Note that the black spacer is under the carriage bolt head to allow for brackets to slide and lock when tightened.
________________________________________________________
2. Mount Morse taper and brackets: Attach "A" bracket to pivot mount with socket head bolt. Then insert Morse taper and lock with the two opposing set screws. Note: shown already inserted into tail stock and with articulating arm installed.
________________________________________________________
3. Insert Morse taper into tail stock
________________________________________________________
4. Adjust brackets to go down into the lathe bed ways
________________________________________________________
5. Tighten bracket bolts to secure position
________________________________________________________
6. Insert locking chain link into notch on "A" bracket, wrap around tail stock and insert link into notch on opposite side
________________________________________________________
7. Extend tail stock quill to lock Morse taper into place
________________________________________________________
8. Tighten tail stock quill lock to secure and restrict tail stock movement in use
________________________________________________________
9. Remove retaining clip on pivot pin to prepare for arm assembly
________________________________________________________
10. Place articulating arm over pivot pin with the bronze thrust washer between mount and arm. Reinstall retaining clip
________________________________________________________
11. Insert Hollowing bar in to mounting block
________________________________________________________
12. If Hollowing bar is to be horizontal insert clevis pin
________________________________________________________
13. Lock clevis pin with hitch pin
________________________________________________________
14. If Hollowing bar is to be indexed to achieve a custom angle lock only with set screws
________________________________________________________
15. Attach swivel clamp. H750-30S for square high speed steel shown or square tool holder for carbide cutter. H750-30R is available for round cutter holders to allow for indexing to custom cutting angles
________________________________________________________
16. Align Hollowing System to center of spindle height using the tool rest and a spindle center reference such as the spur shown. Lock tool rest height and move the tool rest out of the way to mount your project and start turning
________________________________________________________
Hollow Fast Tail Stock Mount System setup completed
